Licensed & insured

AL #06957

Mon–Sat 8am–5pm

EV charger installation

$1,000 for the circuit.

A Level 2 charger is a 240-volt appliance drawing more current than almost anything else in the house. The circuit matters more than the charger does.

ev charger level 2 panel Electrician in a blue shirt and cap repairs an open electrical panel with a power tool in an industrial setting, focused on hands-on work.
Licensed & insured
Alabama license #06957
No deposit, ever
You pay when the job is done.
2-hour window
Late? The $95 diagnostic is on us.
32 years in the trade
Master electrician

What we charge

That’s the same price as an oven, dryer or A/C circuit, because electrically it’s much the same job.

$1,000
The 240-volt dedicated circuit
Installation only, permit included. The charger unit is bought by you, or by us and billed through.
Long runs quoted first. A long run, or a panel with no spare capacity, is quoted separately and in writing before we start.
Your charger is fine. Send us the model and we’ll confirm the circuit it needs before we schedule.
No deposit. You pay when the work is done.
Electrician in a blue shirt and cap repairs an open electrical panel with a power tool in an industrial setting, focused on hands-on work.

Start with the panel

Before anything else, we do a load calculation. A Level 2 charger typically wants a 40 or 60-amp dedicated circuit, and on a 100-amp service that already runs central air, an electric range and a dryer, there may not be room.

That’s not a reason you can’t have one. Load management devices and smaller charge rates both solve it, but it needs to be known before you buy hardware.

What a proper install looks like

Load calculation

Against your actual service size.

Dedicated circuit

Sized to the charger, with the correct conductor gauge for the run length.

Hardwired or receptacle

A NEMA 14-50 receptacle is flexible. Hardwiring is required above 48 amps and is more robust in a damp garage.

GFCI protection

As required by current code.

Neat conduit

Surface runs done squarely, not draped across the wall.

Permit and inspection

Which also matters if you’re claiming any utility or tax incentive.

Where it goes

Cable length and where your car’s charge port sits decide placement more than people expect.

We’d rather spend ten minutes working out where you actually park than mount the unit on the nearest convenient stud and leave you stretching a cable over the hood every night.

Two cars

Worth planning for even if you only have one now.

Two chargers on one circuit with load sharing is straightforward if it’s designed in from the start, and awkward to retrofit.

FAQs about EV charger installs

Still not sure? Call (251) 550-9813, Monday to Saturday, 8 to 5.

Can my house handle a charger?

Usually, but the load calculation decides it. Homes on 100-amp service with electric heat, a range and a dryer are the tight ones. Options include a lower charge rate, a load management device, or a service upgrade.

Receptacle or hardwired?

A NEMA 14-50 receptacle lets you unplug and take the unit if you move. Hardwiring is required above 48 amps and holds up better in a humid Gulf Coast garage. We’ll talk through which suits you.

Do I need a permit?

Yes, and you want one. Beyond the code requirement, an unpermitted 60-amp circuit is an item on your home inspection when you sell, and it can complicate an insurance claim.

Can you install a charger I already bought?

Yes, and that’s the usual way round: the $1,000 is the circuit, not the unit. Send us the model and we’ll confirm the circuit it needs before we schedule.

Do I need to pay a deposit?

No. We don’t take deposits on any job. You pay when it’s done.